Jeg har et GTS fra Creative hvor rammen kun opererer med 315 Mhz istedet for
333 Mhz som annonceret på pakken.
Jeg har fået et svar fra Creative som jeg desværre ikke kan afprøve da min
harddisk er død.
Er der nogle der har en ide om deres svar faktisk kan ændre på rammens
hastighed?
(Frank du må også meget gerne svare)
Her er svaret:
I would suggest that you try the following;
- In the computer's BIOS, try altering these options (unless otherwise
noted):
Video Bios Shadow
Video Bios Cacheable
System Bios Cacheable
C8000 - xxxxx Shadow **Try disabling these values**
Peer Concurrency
Assign IRQ To VGA **This MUST be enabled**
VGA Palette Snoop **This MUST be disabled**
Reset Config Data
Enable ESCD
Power Management **Try disabling this**
Virus Checking **Try disabling this**
PnP Aware OS
AGP Aperture size **approx. half the size of your system RAM**
- Check for additional VGA drivers in safe mode (for both the monitor and
graphics)
- Verify AGP support has been fully installed for that motherboard/operating
system combination
- Verify any on-board VGA adapter has been fully disabled in hardware
- Pull all other cards
- Change the order of cards
- Verify the motherboard is not being overclocked
- Check with the motherboard/system manufacturer for an updated BIOS and
Windows driver updates (for example: Vgart Driver, PCI Bridge, PC Bus
Mastering drivers updates and IRQ Routing updates for W'9x in the case of
VIA or ALI chipsets)
Check out the Intel web site for updates if you have an Intel chipset.
- Turn off anything running in the background such as Screen savers, Virus
Checkers, TSR's or Power Management.
- If you are not using the Com Ports or LPT Port(s), you could disable them
(in the Bios) which will free up System Resources.
Check the specs on your AGP Port:
Voltage on the port should be a 3.3 volts.
It should also supply 6 amps.
Make sure you have the latest drivers available from
http://www.europe.creative.com/Support/drivers/
Kind Regards,
Patricia Moraes Daly
Technical Support
Creative Labs Europe