fakeemail@anthro.ku.dk (Michael Holm) on fredag 27. januar 2006 at 8:47
+0100 wrote:
>Hanne Hertzog <hanne@enterpol.dk> wrote:
>
>>
>> Nu er det jeg spørger, hvorfor stopper Apple ikke den opdatering eller
>> kommer med advarsler?
>> Eller er det bare mig og en masse andre, der er noget i vejen med? Er
>der
>> nogen her, der er stødt på samme problem?
>> hilsen Hanne
>
>det er ikke alle der har problemet, mine ipods virker efter opdatering
>
>så flg. forslag på
>
http://www.macfixit.com/article.php?story=20041221081432908
>
>
>Power cycling the system Simply cycling the power on your system may be
>enough to temporarily eliminate a few FireWire conflict issues.
>
>Shut down your Mac, and disconnect all FireWire devices as well as the
>computer's power cord. Leave the system off for about 10 minutes, then
>plug it back in. First turn your Mac back on, then re-attach the
>FireWire devices one at a time and check for the conflict to resurface.
>
>Disconnect the iSight As noted above, the most common cause of
>interference is Apple's own iSight. In case after case, simply
>disconnecting this single device has eliminated problems with other
>FireWire devices.
>
>Disconnecting the iSight has proved particularly successful for an issue
>where the iPod disappears from the Desktop and from the iTunes playlist,
>while the iPod status screen cycles from the Apple logo to a "Do not
>Disconnect" message over and over.
>
>The exact reasons why the iSight causes more than its fair share
>conflicts with other FireWire devices are many, and sometimes unclear.
>One potential source of conflict, however, could be the unit's high
>bandwidth usage.
>
>The iSight captures video at a 640 x 480 pixel resolution, at 30 frames
>per second in millions of colors. Such throughput uses a significant
>chunk of the standard FireWire port's 400 Mbps bandwidth. As such, when
>other devices are connected, the bandwidth requirements for satisfactory
>performance may not be met.
>
>Apply the latest updates Make sure that your FireWire drives are using
>the latest firmware (check the manufacturers' Web site) and the most
>recent iPod update has also been applied.
>
>Of higher importance, if you have an iSight, is the iSight 1.0.2
>updater. In a large number of cases it has resolved conflicts caused by
>the camera.
>
>Re-apply the most recent Mac OS X combo updater In some cases,
>re-applying the most recent combo updater can resurrect seemingly
>defunct FireWire ports and allow devices -- drives included -- to be
>recognized again.
>
>The most recent combo updater is available from Apple's download page.
>
>--
>Michael Holm - ichat: kiaikido [at] mac.com
>
http://toitsu.dk -
http://alexanderteknik.tk
>
http://parraadgivning.dk -
http://siaholm.dk -
>skal du rejse?
http://danfae.dk - michael[at] toitsu.dk
Der er ingenting der hjælper. Jeg har hverken før eller nu haft firewire
tilkoplet, ej heller ejer jeg iSight og det er en iBook, jeg har brugt.
Det er mit USB kabel, der ikke vil skabe forbindelse til min iPod.-(
Jeg har mistet mit Firewire kabel til min iPod.
Så jeg aner virkelig ikke, hvad jeg skal stille op.
Hilsen Hanne
www.macbruger.dk
____________________
Største og ældste forening
for MacBrugere i Danmark