Kim Bjoern Nielsen wrote:
> > Jeg er ved at smide TDC's Eff.Net. 5711 router på porten, men jeg fik
> > vist rost Cisco for meget før jeg købte en selv.
>
> Jeg formoder således, at alt har virket med 5711'eren? At du bare skifter
> "ATM stikket"?
>
Jeps.
> > Når jeg sætter den op efter :
> >
http://freesbee.wheel.dk/~jesper/1400-proaccess.txt og når til
> > ........
> > interface ATM0
> > no shutdown
> >
> > ...genstarter den #!#¤"& ting. Og det er både med og uden ATM stikket
>
> Kan du dumpe/record fra din consol/telnet når det sker. Så lad os se..
Det kommer her :
System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
C1400 platform with 16384 Kbytes of main memory
program load complete, entry point: 0x4020060, size: 0x14c398
%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
program load complete, entry point: 0x2005000, size: 0x2b66c4
Self decompressing the image :
###############################################################################################################
[OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 1400 Software (C1400-NY-M), Version 12.0(5)T1, RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Tue 17-Aug-99 11:45 by cmong
Image text-base: 0x02005000, data-base: 0x025CED0C
cisco 1401 (68360) processor (revision A) with 13312K/3072K bytes of memory.
Processor board ID 23540470, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
1 ATM network interface(s)
System/IO memory with parity disabled
8192K bytes of DRAM onboard 8192K bytes of DRAM on SIMM
System running from RAM
7K bytes of non-volatile configuration memory.
4096K bytes of processor board PCMCIA flash (Read/Write)
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Press RETURN to get started!
00:00:22: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up
00:00:22: %LINK-3-UPDOWN: Interface ATM0, changed state to down
00:00:22: %QUICC_ETHER-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?
00:00:22: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 1400 Software (C1400-NY-M), Version 12.0(5)T1, RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Tue 17-Aug-99 11:45 by cmong
00:00:23: %LINEPROTO-5-UPDOWN: Line
Router> protocol on Interface Ethernet0, changed state to down
00:00:23: %LINEPROTO-5-UPDOWN: Line protocol on Interface ATM0, changed state
to down
00:00:24: %LINK-5-CHANGED: Interface ATM0, changed state to administratively
down
00:00:24: %LINK-5-CHANGED: Interface Ethernet0, changed state to
administratively down
Router>enable
Router#configure
Configuring from terminal, memory, or network [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#interface ATM0
Router(config-if)#no shutdown
--------
(Det skal lige siges, at den står uden ATM og Ethernet forbindelse.)
Og det er så her at det går galt. Men underligt nok gør den det ikke nu. Og
det fatter jeg jo ikke en brik af.
Så jeg tror jeg vil smide den ind på kontoret imorgen og se hvad der sker når
der kommer noget ATM på den.
>
>
> > Jeg har prøvet både med IOS 12.0.5 og 12.1.1. Der er ingen forskel...
>
> Og du er sikker på at det er helt korrekt IOS? Hvilket feature set?
> c1400-????-mz
Tjaa... Den har en 12.0(3)i rommen, en 12.0(5) på flash kortet. Og hvis bare
man kunne få en 12.0(5) over i rommen så den er noget hurtigere til at starte
op.
Fra 'show version' : System image file is "flash:c1400-ny-mz.120-5.T1"
>
>
> > Og så kommer det så : Er det mig der er en skovl, eller er der noget
>
> - så er jeg en spade
Hehe... Takker og bukker mange gange...
>
>
> > Skal du bruge mere info for at kunne hjælpe mig, er jeg den glade giver
>
> Prøv at svare på ovenstående...
>
Var det godt nok ?
PKN